The colors that appear on the screen and in print may not match actual applied color.
Coverage Spread rates will vary depending on the porosity of the surface. On smooth surfaces, 3000 series covers approximately 400-600 square feet per gallon, 19200 series covers approximately 250-350 square feet per gallon. Where to Use Cabot Wood Toned Deck & Siding Stain is for use on new or reconditioned wood only, including decks, siding, roofs, shingles, shakes, trim and on log homes. Cabot Wood Toned Deck & Siding Stain can be applied to all natural wood species such as cedar, fir, pine, cypress, spruce, redwood and plywood, including Texture 1-11, and will produce outstanding results on all premium grade lumber. It can also be applied to pressure-treated wood. Preparing Your Surfaces Proper surface preparation is the key to maximum performance. The durability of this product can be impaired by an unsound or poorly prepared surface. It is very important that the surface be clean of all dirt, mildew stains, loose wood fibers and other foreign matter. In order to be effective, a stain must be able to penetrate. Surfaces must be structurally sound and absolutely dry. (Moisture content must be below 15%, or wood must be exposed to dry weather a minimum of 3 to 5 days.) Weathered wood surfaces must be sanded or scrubbed to bare wood with a detergent solution or Cabot Problem-Solver® Wood Cleaner and a stiff bristle brush, or power washed to remove the surface layer of all loose wood fibers, dirt, mildew stains, chalky residue and other foreign matter. Use Cabot Problem-Solver Wood Stripper to help remove oil-based finishes from wood surfaces such as cedar, redwood, pine, cypress, fir and pressure-treated wood. Use Cabot Problem-Solver Wood Brightener to easily remove nail and metal rust stains, and renew the wood's appearance. New smooth wood that is unseasoned or appears shiny should be allowed to weather sufficiently before staining, but generally no longer than three months. Application For best results, use a high quality pad applicator or stain brush. If you must spray, always backbrush immediately after each section is coated to ensure proper penetration. To avoid lap marks, always start at one edge and follow through to the end of the board. It is very important to apply only one coat. Restain depending on sun exposure and wear every 1-2 years. Cleanup and Disposal 3000 series: Clean brushes and equipment with mineral spirits 19200 series: Before drying, clean brushes and equipment with soap and water. Use mineral spirits after drying. Dispose of empty cans or unused portion in accordance with local, state and federal regulations. Close container when not in use. Danger: Rags, steel wool or waste soaked with this product may spontaneously catch fire if improperly discarded. Immediately after each use, place rags, steel wool or waste in a sealed, water-filled metal container. Dispose of according to local regulations.
