DAP Dynaflex 230 Elastomeric Latex Sealant stays flexible. Silicone performance. Withstands 50% total joint movement.
For Best Results:
Surface Preparation & Application:
1. Surface must be clean, dry and free of all old caulk, dirt, dust, and grease.
2. Cut nozzle at 45° angle to desired bead size.
3. Load cartridge into caulking gun.
4. Fill gap with sealant, pushing sealant ahead of nozzle.
5. For a neat finish, smooth bead of sealant with a finishing tool.
6. Clean up excess sealant with a damp cloth before it skins over (15 minutes).
7. Allow sealant to dry 2-4 hours before painting with latex or oil-based paints.
Cool or humid conditions or type of paint used may require longer dry time.
Cool or humid conditions or type of paint used may require longer dry time.
8. Reseal for storage and reuse.
For Best Results:
• Applyin temperatures above 40°F (4,44°C).
• Do not apply if rain or freezing temperatures are forecasted or before full cure
can occur. Cold weather and high humidity will slow down cure time.
can occur. Cold weather and high humidity will slow down cure time.
• Do not use below waterline or for marine or automobile applications, or filling surface defects.
• Joint depth should not exceed 1/2” (1,30 cm)wide by 1/2” (1,30 cm)deep.
If joint exceeds 1/2” (1,30 cm) deep use foam backer rod.
If joint exceeds 1/2” (1,30 cm) deep use foam backer rod.
• Store sealant away from extreme heat or cold.
Shelf Life:
12 Months
Coverage:
55 linear ft. at a 3/16" bead size. (16,76 m linear feet at a 0,47 cm bead size)
Clean Up:
Clean up excess uncured sealant with a damp cloth or sponge before it skins over. Wash hands with warm water and soap. Dried material must be cut or scraped away.
