Description

DAP Ready-Mixed Concrete Patch is a ready-to-use concrete crack filler. It is fortified with a vinyl polymer to increase adhesion, durability and strength. Can be used for interior or exterior repairs to concrete and masonry surfaces.

Surface Preparation & Application

• Use a wire brush, chisel, or similar tool to remove

all loose material, dust, dirt, oil and grease from

the area to be repaired. Use a solvent to remove oil and

grease. Rough up the surface one or two inches beyond the

area to be repaired for a good bond. Dampen

the area with clean water – DO NOT FLOOD.

• Apply concrete patch exactly as it comes from

the container with a flexible putty knife, broad knife, or

trowel. Smooth and feather edge.

• If area to be patched is deeper than 1/2 inch, apply
patch in 1/4-inch layers, maximum depth 1 inch,

allowing each application to dry.

• If used as a “glue,” apply at least 1layer of concrete patch to

both surfaces to be repaired. Push together. Be sure at least 1
inch of patch remains between the surfaces for proper bonding.
For extra adhesion in heavy traffic area, prime area to be patched
with DAP®Bonding Liquid.

• Patched areas may be painted with a quality latex pain

t if desired (after product has achieved full cure in approximately
28 days, preferably primed with a exterior latex primer). If material
settles in container, mix thoroughly before use. If material is still too
stiff, add a small amountof water (up to 4 teaspoons) and mix

thoroughly.

Drying time:

2 to 4 hours, longer if humidity is high. Allow to dry overnight

before driving over patched area. Do not apply if rain is likely

within drying period or if temperature is apt to drop below 40°F

Storage:

Keep from freezing. Close container tightly after each use.

Shelf Life:

1 year

Temperatures:

Apply in temperatures greater than 40°F

Clean Up: