Minwax High Performance Wood Filler 6 Oz. - (Box of 6)

Minwax® High Performance Wood Filler is used to fill gouges and holes in split, damaged or rotted exterior or interior woods. It is weather, water, and rot resistant. Minwax® High Performance Wood Filler is also effective as a wood adhesive where you can anchor screws and secure loose joints in furniture. It strongly bonds to wood as well as almost any rigid surface including ceramics, concrete, metal, and fiberglass.

Directions
1. Area must be clean, dry and free from paint varnish, dirt, and grease. If working with rotted or soft wood, remove loose material and apply Minwax® High Performance Wood Hardener to strengthen wood fibers and to form a solid base for filling.
2. Scoop golf ball size amount of filler into plastic lid and squeeze in a thin 3/4 inch long line of hardener from the tube. Mix thoroughly. (Mix only as much as can be used in 15 minutes.)
3. Apply the mixed paste immediately to the area to be repaired. Spread on a thin layer followed by sufficient product to fill the gap. Slightly over-fill to allow for sanding down. Work quickly as the mixture remains workable for about 10 minutes at room temperature. (To fill deep holes, spread on 1/8 inch thin layers one at a time until the hole is filled.)
4. After approximately 20 minutes, the repair should be hard enough to be carved and shaped using a sharp modeling knife.
5. Wait at least 30 minutes to sand, plane or file.
6. The Minwax® High Performance Wood Filler can then be painted or stained. To stain Minwax® High Performance Wood Filler, see tips for staining Minwax® High Performance Wood Filler inside cap sticker.

Cleanup: acetone following manufacturer’s safety instructions

Note: This product absorbs stain differently than wood. Therefore, it is unlikely that exact color match to the original wood will be achieved.