Minwax Oil-Based Clear Protective Finish Pint Satin

Water Based Helmsman® Spar Urethane is a crystal clear, water-based finish that is specially formulated to protect wood against nature’s toughest conditions. Water Based Helmsman® forms a protective barrier against rain and moisture and the ultraviolet absorbers found in Water Based Helmsman® reduce the graying and fading effects of the sun. Because it’s water-based, it has little odor and cleans up easily with warm water. Water Based Helmsman® Spar Urethane is not recommended for use on floors.

DIRECTIONS:

1. Surface must be dry and free of paint, wax, grease, polish, old finishes in poor condition or any foreign matter.
2. Sand to obtain a smooth, uniform surface. Do not use steel wool. Remove all dust with a damp cloth.
3. If desired, apply stain, such as Minwax® Wood Finish™, to unfinished interior wood surfaces. Follow directions for application instructions and dry times.
4. Stir well before and occasionally during use.
5. Apply a thin coat of Water Based Helmsman® using a high quality synthetic bristle brush. On unfinished wood, apply sufficient material to seal open joints, edges and end-grain.
6. Let dry at least two hours, then sand entire surface lightly with very fine sandpaper (220 grit) to ensure an even finish and proper adhesion of additional coats.
7. Apply second coat. Water Based Helmsman® requires a third coat - repeat step 6 before application. Note: For exterior surfaces or for previously unfinished wood, four coats are recommended.
8. After final coat, allow 24 hours before normal use. If applied to countertops, allow 72 hours before normal use.

Clean Up: Clean application tools with warm water immediately after use.

Coverage: Approximately 125 sq. ft. per quart.

Note: Dry times are based on good ventilation, temperature of 77°F and 50% relative humidity. Lower temperature, higher humidity, lack of air movement or application of thick coats will extend drying times. Always test surface for tackiness between coats. When used for exterior applications, maintain by lightly sanding and adding an additional coat(s) as conditions require.

Water Based Helmsman® is not recommended for large exterior surfaces where maintenance would be difficult, such as decks and siding. Slight ambering may be experienced when Water Based Helmsman® is applied over light-colored stains or wood surfaces. Always spot test on an inconspicuous area to ensure satisfactory results.