
1. Surface must be dry and free of old finishes in poor condition, wax, grease, polish, dirt or other foreign matter.
2. Sand to obtain a smooth, uniform surface. Remove all dust with a cloth dampened with mineral spirits.
3. If desired, apply stain, such as Minwax® Wood Finish™, following the label directions for application instructions and dry times.
4. Shake Wipe-On Poly container thoroughly before use.
5. Put a liberal amount of Wipe-On Poly on a clean, soft, lint-free cloth and rub into the wood.
6. Allow to dry at least 2-3 hours. Sand entire surface lightly with very fine sandpaper (220 grit) or fine steel wool. Remove all sanding dust.
7. Apply a second coat in the same manner as the first. If a third coat is desired, repeat Step 6 before application.
8. Allow final coat to dry 24 hours before normal use.
Cleanup: For easy cleanup, use mineral spirits or paint thinner.
Coverage: Approximately 125 sq. ft. per quart.
Floors: Wipe-On Poly may be used to touch up small scratches on floors. Apply carefully as gloss level may not be identical to the existing floor finish.
Note: Wipe-On Poly is not recommended for general use on floors.