Rust-Oleum Specialty Glow In The Dark glows for up to 2 hours. Apply to wood, metal, plaster, masonry or unglazed ceramic. Washes with soap and water. PRODUCT FEATURES: Fast-drying Indoor use only Great for kids rooms, school projects and holiday decor
PRIMING
APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with
fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. Lightly sand
glossy surfaces.
WARNING! If you scrape, sand, or
WARNING! If you scrape, sand, or
remove old paint, you may release lead dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS SUCH AS BRAIN DAMGE,
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the U.S.EPA/Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
1-800-424-LEAD or log on to www.epa.gov/lead.
PRIMING
Use of a Rust-Oleum White primer provides added
corrosion protection, enhances adhesion and hiding, and
is especially recommended for metal and wood surfaces.
Recommended primers include
224430T Painters TouchFlat White Primer
7980502 American Accents Flat White Primer
249058 Painters Touch White Primer
7980502 American Accents Flat White Primer
249058 Painters Touch White Primer
APPLICATION
Apply only when air and surface temperatures are above
50ºF (10ºC) and 90ºF (32ºC) and humidity is below 85% to
ensure proper drying. Before using, mix thoroughly to
ensure any settled pigment is re-dispersed. Thinning is
not required. Avoid painting in direct sunlight or on hot
surfaces. Use a good quality synthetic brush
or ¼”-⅜”nap roller.
or ¼”-⅜”nap roller.
Avoid excessive brushing as this will reduce film
thickness and protection. Use light even strokes to ensure
smooth and uniform flow. Apply two coats 45 minutes
apart to achieve maximum glowing effect.
CLEAN-UP
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to touch in 45 minutes, dries to handle in 2 hours,
and can be recoated in 45 minutes.
CLEAN-UP
Clean brush and other application tools immediately with
soap and water.
