Name: Rust-Oleum High Heat
Brand: Rust-Oleum
SKU: 77785
Availability: InStock

Description

Rust-Oleum Specialty High Heat retains color and finish up to 1000º F. Apply to grills, wood-burning stoves, radiators, engines and other metal items. Provides rust protection and a rich, satin finish. PRODUCT FEATURES: Indoor/Outdoor Durable, corrosion-resistant Scroll to bottom of page for color chart

PAINTING CONDITIONS

Use outdoors or in a well ventilated area such as an open

garage. Use when temperature is between 50-90ºF (10-

32ºC) and humidity is below 85% to ensure proper drying.

Priming is not recommended. Do not use on metal directly

exposed to open flame or in direct contact with food, such

as a grill grate. If using sprays, avoid application in very

windy and dusty conditions. Cover surrounding area to

protect from spray mist.

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical

contaminants by washing the surface with a commercial

detergent, or other suitable cleaning method. Rinse with

fresh water and allow to thoroughly dry. Remove loose

paint and rust with a wire brush or sandpaper. Previously

coated surfaces must be sound and in good condition.

Smooth, hard, or glossy finishes should be scarified by

sanding to create a surface profile. Removal of old paint

by sanding, scraping or other means may generate dust or

fumes that contain lead. LEAD IS TOXIC. Contact the

U.S.EPA/Lead Information Hotline at 1-800-424-LEAD or

log on to www.epa.gov/lead.

APPLICATION

Sprays: Shake can vigorously for one minute after the

mixing ball begins to rattle. If mixing ball fails to rattle DO

NOT STRIKE CAN. Contact Rust-Oleum. Shake often

during use. Hold can upright 10-16” from surface and

spray in a steady back-and-forth motion, slightly

overlapping each stroke. Keep the can the same distance

from the surface. Keep the can in motion while spraying.

Apply two or more light coats a few minutes apart to avoid

drips and runs. Do not use near open flame.

Brush Goods: Mix thoroughly to ensure any settled

pigment is re-dispersed. Thin material only if necessary

with mineral spirits. For brush or roller application, thin no

more than 5%. Do not thin with gasoline, lacquer thinner,

turpentine, etc. Apply with a good quality brush, nap roller,

or conventional spray gun. A second coat is not

recommended.

DRY & RECOAT TIMES

Sprays: Dries to touch in 30 minutes and to handle in 1-2

hours. Allow paint to dry for 1 hour before heating.

Product may emit smoke and harmless odor.

Brush Goods: Dry and recoat times are based on 70ºF

and 50% relative humidity. Allow more time at cooler

temperatures. Dries to touch in 2-4 hours, to handle in
5-9 hours, and is fully dry in 24 hours. Allow paint to dry 24

hours before heating. When using the subject surface for

the first time, open windows and provide ventilation as the

new paint finish may emit smoke

CLEAN-UP

Sprays: Clean valve immediately after use by turning can

upside down and depressing spray button for 3-5 seconds

(some paint will be sprayed out, so be careful to not

inadvertently spray yourself or other objects). Clean-up

wet paint with xylene or mineral spirits. Properly discard

empty container. Do not burn or place in home trash

compactor.

Brush Goods: Clean brush, roller, and other tools with

mineral spirits. Dispose of soiled rags properly.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.