Name: Rust-Oleum Stops Rust Hammered Spray Paint
Brand: Rust-Oleum
SKU: 12682
Availability: InStock

Description

Rust-Oleum Stops Rust Hammered hides flaws and imperfections found in scratched, rusted or pitted metals. Apply directly over rust. Works on wheelbarrows, lighting fixtures, wheel rims and other metals as well as wood, concrete and masonry.PRODUCT FEATURES: Indoor/Outdoor Gloss Durable, corrosion-resistant Scroll to bottom of page for color chart Item Numbers Ending In the Letter "R" Are Sold Only By The Box and Usually Ship in 10 to 14 Business Days. These are special order items and can NOT be returned for credit or exchange and the order can NOT be canceled once placed. This Item Can NOT Be Shipped Internationally

Use outdoors or in a well ventilated area such as an open garage.

Use when temperature is between 50°F (10°C) and 90°F (32°C)

and humidity is below 85% to ensure proper drying. Do not

apply to surfaces, when heated, exceed 200°F (93°C). Do not

apply to galvanized steel. Avoid spraying in very windy and dusty

conditions. Cover surrounding area to protect from spray mist.

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical contaminants

by washing the surface with a commercial detergent, or other

suitable cleaning method. Rinse with fresh water and allow to

thoroughly dry. Remove loose paint and rust with a wire brush or

sandpaper. Previously coated surfaces must be sound and in good

condition. Smooth, hard, or glossy finishes should be scarified by

sanding to create a surface profile. WARNING! If you scrape, sand,

or remove old paint, you may release lead dust. LEAD IS TOXIC.

Contact the U.S.EPA/Lead Information Hotline at 1-800-424-LEAD

or log on to www.epa.gov/lead.

PRIMING

Use of a Rust-Oleum primer provides superior adhesion and

hiding and is especially recommended for bare wood and metal.

The following primers are recommended.

7769

Rusty Metal Primer

7780

Clean Metal Primer

2081

Light Gray Auto Primer

2067

Red Auto Primer

2089

Dark Gray Auto Prime

PAINTING

Shake can vigorously for one minute after the mixing ball

begins to rattle. Shake often during use. Hold can upright

10-12" from surface and spray in a steady back-and-forth

motion, slightly overlapping each stroke. Keep the can the

same distance from the surface. Keep the can in motion while

spraying. Apply two or more light coats a few minutes apart to

avoid drips and runs. Do not use near open flame.

DRY & RECOAT

Dry and recoat times are based on 70°F and 50% relative

humidity. Allow more time at cooler temperatures. Dries to

touch in 15 minutes and fully dry in 24 hours. Recoat at any

time.

CLEAN-UP

Wipe off tip before storing. Clean-up wet paint with xylene or

mineral spirits. Properly discard empty container. Do not burn

or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object into

can valve opening.