New Rust-Oleum Universal is specifically formulated to work on diverse surfaces including wood, plastic, metal, wood, concrete and even vinyl. The Rust-Oleum Universal advanced spray system can spray from any angle — even upside down. PRODUCT FEATURES: For use on interior / exterior environments One Universal coating for diverse substrates Ultimate flexibility for extreme applications Maximum adhesion for demanding substrates Fast, efficient coverage Fade and chip resistant Rust preventative Scroll to bottom of page for color chart Item Numbers Ending In the Letter "R" Are Sold Only By The Box and Usually Ship in 10 to 14 Business Days. These are special order items and can NOT be returned for credit or exchange and can NOT be canceled once the order is placed. This Item Can NOT Be Shipped Internationally 
Use outdoors or in a well ventilated area such as an open garage.
Use when temperature is between 50-90ºF (10-32ºC) and humidity
is below 65% to ensure proper drying. Do not use on objects that may exceed
Use when temperature is between 50-90ºF (10-32ºC) and humidity
is below 65% to ensure proper drying. Do not use on objects that may exceed
200ºF (93ºC) surface temperature. Do not apply to galvanized steel.
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse
with fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. Previously
coated surfaces must be sound and in good condition.
Smooth, hard, or glossy finishes should be scarified by
sanding to create a surface profile.
APPLICATION
DRY & RECOAT
CLEAN-UP
CLOGGING
WARNING!
If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-Approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
ww.epa.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Prior to use, slide off the red safety clip from the
trigger. Hold can upright 8-12” from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or
more moderate coats at moderate speed to avoid drips
and runs. Do not usenear open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 30 minutes, to handle in 1 hour, and is fully dry in
24 hours. Recoat within 1 hour or after 48 hours.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean
up wet paint with xylene or mineral spirits. Properly
discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.
