UGL 222 Spackling Paste

UGL

$0.00
SKU:
31606
option-grid:
true
__sku:
31606
wide:
true
Adding to cart… The item has been added
A ready-to-use spackling compound for interior and exterior patching of cracked plaster, filling nail holes and smoothing surface imperfections on unprimed wood. May be painted. Contains no asbestos. Rated best buy by a leading consumer magazine.

The product is ideal for patching cracked plaster, filling nail holes, repairing wall tile and smoothing surface imperfections on unprimed wood.

COMPOSITION: Latex
SHEEN: N/A %
WEIGHT SOLIDS: 69.9% %
VOLUME SOLIDS: 47.9%
DENSITY (LBS./US GAL.): 13.1
VISCOSITY: Stiff paste
pH: 8+
COLORS: White

DRY TIME: • 2 hours Note: Maximum cure and dry time will
be prolonged when slightly humid and damp, cool conditions prevail.

CLEAN UP: Soap and water Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations.

COVERAGE (CU. IN./US QT.): • 56 cu. in./qt. Note: Actual coverage will vary depending upon application method, surface texture and porosity.

RECOMMENDED FILM THICKNESS/COAT: N/A
FLASH POINT: N/A
SHELF LIFE: N/A
FREEZE/THAW: Keep from freezing

Remove all loose dirt and scaly or powdery material. All metal, including nail heads, should be primed with a metal primer. UGL 222 Spackling Paste and surface temperature of area to be patched must be above 50°F. All exterior applications must be painted.

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH- approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Apply with a putty knife or broad knife. Deep cracks should be filled in two steps, allowing the material to dry thoroughly between applications. To patch sand-finish plaster, add white sand to match the texture of the adjoining area.

UGL 222 Spackling Paste can be painted over immediately after drying with any type of decorative finish.
Prolonged contact with skin during mixing or application may cause irritation some cases. If splashed on skin or in eyes, flush thoroughly with water.

This product contains a chemical(s) known to the State of California to cause cancer and birth defects or other reproductive harm.

DO NOT TAKE INTERNALLY. AVOID BREATHING DUST KEEP OUT OF REACH OF CHILDREN