SureGrip Seam and Repair Adhesive “Sticks & Stays!” The professional strength formula sets faster and bonds stronger than traditional wallcovering seam adhesives. It seals down stubborn curling seams, loose edges, tears and overlaps in just 10 seconds and features a non-drip formula that makes application neat and easy. It dries clear, so it won’t stain wallpaper or paint and cleans up easily with water – even after it’s dried. * Seals down stubborn curled seams, edges, tears and overlaps * Professional strength – sets faster and bonds stronger * Non-drip – makes application easy and neat * Dries clear, non-staining * Cleans up easily with water
APPLICATION
Use only when temperature is between 50-100°F
(10-38°C). Adhesive is ready to use. Apply a thin coat under
(10-38°C). Adhesive is ready to use. Apply a thin coat under
edges. Make sure the adhesive gets back into areas
where the wallcovering starts to separate from the surface.
For separated seams, dampen the front and back of loose
wallcovering or border with a damp sponge. Wait 5
minutes before applying adhesive. Smooth until flat.
If the edges are curled, press down and hold for 10 seconds.
Avoid contact with the surface of embossed or delicate
wallcovering.
CLEAN-UP
TOOL CLEAN-UP
STORAGE
DRY TIME
Drying time will vary depending on the wallcovering type,
temperature, ventilation and humidity in the room.
CLEAN-UP
Remove excess adhesive on or around the wallcovering
or border immediately with a clean damp sponge or cloth.
Blot dry with a soft towel. Additional effort may be required
if adhesive is allowed to contact the surface of embossed
or textured vinyl. Close tube tightly after each use.
TOOL CLEAN-UP
Clean tools with warm water.
STORAGE
Protect from freezing. Always keep the container tightly
closed and store in a cool dry place at temperatures
between 40-100°F (4-38°C). Normal storage life is one
year. The disposal of excess or left over product should
conform to local laws regarding water-based products.
