This premixed wall and ceiling texture comes ready-to-use in a bottle that acts as the guns hopper. Bottles snap directly onto any of our spray texture guns. • Ready-to-use bottles that act as the hoppers • Snaps directly onto guns Instructions:
Instructions:
Protect surrounding area from overspray. Prepare surface by removing grease, loose plaster, peeling paint, etc. Texture will adhere to most clean surfaces.
- Shake texture well. Open the breather cap and puncture the breather hole on the texture bottle. Close the cap over the breather hole.
- Remove the snap cap from the bottle. Snap the gun firmly onto the texture bottle and twist. Make sure the bottle lock on the gun passes through the slot on the top of the bottle and the pin engages in the opposite hole. Turn the bottle lock.
- When ready to spray the texture, make sure the breather cap is open.
- Replace snap cap and breather cap when complete.
